Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Fabbing New Rear Shock Mount
#6
You're right...there is a point where too far forward negates that benefits of the shock. I spent a lot of time looking for a solution, and I'll take any advice I can get. I'm running Caddie calipers in the rear and the stock mount location conflicts with the caliper. I looked at inboard and for travel there is no better solution but I don't want the body roll that accompanies it. After prepping the frame, I'm going to test fit these with a single shock to see the best angle vs travel I can get.
Reply


Messages In This Thread
Fabbing New Rear Shock Mount - by Bighorn - 11-19-2008, 03:33 PM
Fabbing New Rear Shock Mount - by SC74 - 11-19-2008, 04:21 PM
Fabbing New Rear Shock Mount - by blazinchuck - 11-19-2008, 05:27 PM
Fabbing New Rear Shock Mount - by Bighorn - 11-19-2008, 05:57 PM
Fabbing New Rear Shock Mount - by blazinchuck - 11-19-2008, 06:22 PM
Fabbing New Rear Shock Mount - by Bighorn - 11-19-2008, 07:01 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  1977 Ford Bronco rear ended 9" rebuild Crawdad 10 5,138 01-19-2017, 12:53 PM
Last Post: snipes243
  Rebuilding used rear leaf springs Crawdad 5 4,288 12-12-2016, 11:54 AM
Last Post: Crawdad
  Lighted rear view mirror chuzie 6 4,708 06-20-2015, 12:18 AM
Last Post: chuzie
  Front shock mounts snipes243 14 3,933 03-01-2015, 07:51 PM
Last Post: scbronco
  rear main seal snipes243 5 2,972 05-03-2014, 11:45 AM
Last Post: chuzie
  stock rear drums scbronco 11 2,586 03-06-2014, 08:09 PM
Last Post: Bronco Biff
  Late 70s Cadi rear disc brakes for 77 banjo rear end Crawdad 11 3,869 01-11-2014, 12:26 AM
Last Post: Crawdad
  77 EB Rear Drive Shaft Dropped - Second time in six months UTFLIWGYA 4 2,034 12-01-2013, 10:38 PM
Last Post: broncomatt
  Grinding sound from rear end area when driving Crawdad 10 4,472 02-09-2013, 09:33 PM
Last Post: blazinchuck
  '94 351 Rear Main replacement JayT 5 1,651 12-22-2012, 05:34 PM
Last Post: JayT

Forum Jump:


Users browsing this thread: 2 Guest(s)