08-17-2008, 12:35 AM
I found some more trivial information today. Seems a 10.25 Sterling uses the same cup races on the inner bearings. I'm trying to cross my seal #'s over to see if they are the same also. Then I'll have to find out if there is enough material in the outer part to machine about .200" for my outer race.
I'm going to try to make it to the Pull-a-Part to look for a set of Sterling hubs.
I'm going to try to make it to the Pull-a-Part to look for a set of Sterling hubs.
'72 TBA...