|
Axle Tube Vents
|
03-01-2013, 07:10 PM
the factory setup went from the mounting bolt for the brake line up to the frame corner (where the fuel line bends). It usualy had a blastic cap. You dont want use a one way valve as you want it to breath in and out. I personaly like using an old small fuel filter. That keeps the bugs out and keeps the air flowing, one suggestion is if you are playing in the mud or water much drill out the stock vent tube so it can flow more air.
[SIGPIC][/SIGPIC]
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Axle Tube Vents - by Casey835 - 03-01-2013, 02:35 PM
Axle Tube Vents - by Carolinaoffroad - 03-01-2013, 04:17 PM
Axle Tube Vents - by Carolinaoffroad - 03-01-2013, 04:20 PM
Axle Tube Vents - by broncomatt - 03-01-2013, 07:10 PM
Axle Tube Vents - by Casey835 - 03-01-2013, 08:20 PM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| ***9" Axle Gurus...Ring gear dug into pilot housing!** | chuzie | 7 | 2,434 |
12-05-2012, 12:35 AM Last Post: chuzie |
|
| Axle / Gear gurus help!! | SC74 | 4 | 2,444 |
03-28-2012, 08:52 AM Last Post: SC74 |
|
| F150 axle shaft tech | blazinchuck | 12 | 3,109 |
12-03-2011, 09:34 PM Last Post: broncosbybart |
|
| C4 Trans Dipstick Tube | SC74 | 5 | 2,741 |
10-24-2011, 01:35 PM Last Post: chuzie |
|
| Stuck rear axle? (9") | Action | 6 | 1,542 |
06-24-2011, 09:42 PM Last Post: jollygrngiant |
|
| rear axle shims? | berg bronco | 15 | 2,479 |
01-04-2011, 09:52 PM Last Post: blazinchuck |
|
| axle | bluebooger | 6 | 1,389 |
12-02-2010, 12:45 AM Last Post: broncosbybart |
|
| Axle Seal Leak.. Again! | 73Bronc | 13 | 3,305 |
10-15-2010, 01:50 PM Last Post: chuzie |
|
| Kick Down Tube C4 | jrshepherd | 4 | 3,493 |
03-04-2010, 10:33 PM Last Post: bucketobolts |
|
| 79 F150 Dana 44 Axle Question | 2000F150SAS | 3 | 2,614 |
01-31-2010, 03:53 AM Last Post: broncomania |
|
